Pay in installments of $51.00 with
,
and
Shipping Estimate
USA
- USA
- CAN
- USA
- CAN
Ships within 48 hours · Estimated delivery Jul 24 - Jul 29
Promo Codes Available:
For Your Every Summer RSVP, with Code: SUMMER15
Description
Supermicro Motherboard MBD-X11SRA-O Xeon Single Socket LGA 2066 C422 Max.256GB PCI Express ATX RetailMPN MBD X11SRA O Physical Stats Form Factor: ATX Processor Cache CPU: Intel Xeon Processor Skylake W , Intel Xeon Processor W Family. Single Socket R4 (LGA 2066) supported, CPU TDP support Up to 140W System Memory Memory Capacity: Up to 256GB Registered ECC RDIMM, DDR4 2666MHz, Up to 512GB Registered ECC LRDIMM, in 8 DIMM slots Memory Type: 2666 2400 2133 1866 1600MHz ECC DDR4 SDRAM 72 bit 288 pin RDIMM LRDIMM DIMM Sizes: 4GB, 8GB, 16GB, 32GB, 64GB
MPNMBD-X11SRA-O
Physical Stats
Form Factor: ATX
Processor/Cache
CPU:
- Intel Xeon Processor Skylake-W , Intel Xeon Processor W Family.
- Single Socket R4 (LGA 2066) supported, CPU TDP support Up to 140W
System Memory
Memory Capacity: Up to 256GB Registered ECC RDIMM, DDR4-2666MHz, Up to 512GB Registered ECC LRDIMM, in 8 DIMM slots
Memory Type: 2666/2400/2133/1866/1600MHz ECC DDR4 SDRAM 72-bit 288-pin RDIMM/LRDIMM
DIMM Sizes: 4GB, 8GB, 16GB, 32GB, 64GB
Memory Voltage: 1.2V
On-Board Devices
Chipset: Intel C422
SATA:
- Intel C422 controller for 6 SATA3 (6 Gbps) ports RAID 0,1,5,10
- iRST enabled, only SATA2 to SATA5 support RAID.
Network Controllers:
- Single LAN with Intel PHY I219LM LAN controller
- Single LAN with Aquantia 5G LAN chip AQC108
Audio: ALC 1220 7.1 HD Audio
Input / Output
USB:
- 6 USB 2.0 ports (2 rear + 4 headers),
- 6 USB 3.0 ports (4 rear + 2 headers),
- 2 USB 3.1 ports ( + 2 Type A)
Serial Port / Header: 1 COM Port (1 header)
TPM: 1 TPM Header
Expansion Slots
PCI-E:
- 3 PCI-E 3.0 x16,
- 1 PCI-E 3.0 x4
- 3xPCI-E3.0 x16 Slots(8/16/16 (Skylake-W 48 lanes), 1xPCI-E3.0x4 slots
M.2:
- M.2 Interface: 2 PCI-E 3.0 x4
- Form Factor: 22110
- Key: M-Key (RAID 0,1 support)
- M-Key for SSD and Optane(up to Intel POR). Intel VROC licence kit is needed to enable RAID.
System BIOS
BIOS Type: UEFI 256Mb
Management
Software: AMT, SuperDoctor 5, Watchdog
PC Health Monitoring
Voltage: +1.8V, +12V, +3.3V, +5V, +5V standby, 1.05 (PCH), 1.2V (VDIMM), 3.3V standby, 5 (4-pin), Chassis intrusion header, Monitors CPU voltages, Monitors for CPU Cores, System temperature, VBAT
FAN: 5x 4-pin fan headers (up to 5 fans), Fan speed control, Overheat LED indication, PWM fan speed control
Temperature: CPU thermal trip support, Monitoring for CPU and chassis environment, PECI, Support to monitor Supermicro AOC temperatures from IPMI or SD 5
LED: CPU / System Overheat LED
Other Features: ACPI power management, ATX Power connector, Chassis intrusion detection, Chassis intrusion header, Control of power-on for recovery from AC power loss, CPU thermal trip support for processor protection, Intel Smart Response Technology, RoHS, Voltage and Frequency Overclocking, WOL
Operating Environment
Operating Temperature Range: 0oC to 50oC (32oF to 122oF)
Non-Operating Temperature Range: -20oC to 60oC (-4oF to 140oF)
Operating Relative Humidity Range: 10% to 85% (non-condensing)
Non-Operating Relative Humidity Range: 10% to 95% (non-condensing)
Item Dimension ( L inch x W inch x H inch)
NA
Weight
5.00 lb
Shipping Notes
- Free Standard Shipping on $100+ Orders to the USA.
- Except Preorder products are shipped in 48 hours.
- Delivery to the USA:
- Standard Shipping : 3-10 business days
- If time is of the essence, please consider selecting expedited delivery for faster service.
Exchange/Return Notes
- We offer a 30-day return/exchange service after receiving.
- Final sale items are not eligible for returns or exchanges.
- To process your return/exchange, please contact us at [email protected]
- Please click here for more details>>> Return & Exchange Policy
4.8 ★★★★★
Based on 10 reviews
Sort
Product Reviews
★★★★★ 5
Great product
Style: Modifier
Noticed a more smooth engine idle and less tick noise in my Tacoma. Is a win
WAS THIS REVIEW HELPFUL?YesReportShare
Reviewed in the United States on April 1, 2026
★★★★★ 5
My 2018 Mustang GT BBQ Tick went away but came back.
Style: Modifier
Update 1-26-2019:
The BBQ/Typewriter tick came back this morning. So, I'd say that if you're trying to use the Ceratec to quiet the tick, it will work for a little while, but will eventually return. I don't think there's anything else that can be done to quiet the tick and it's a crap shoot if you get it serviced. In my case, it only ticks during warm up after the transition from high idle, and goes away completely once the entire engine is fully warmed up, so I'm just going to live with it. I'm still giving the Ceratec a 5 because it did reduce my friction enough for a small MPG improvement, so I believe it works as advertised and I'm not going to blame them for not silencing the tick.
Update 1-20-2019:
After a few days with only the one bottle poured in, my tick came back. Since one bottle is only 1/2 the recommended concentration for the 10 quarts in a 2018 Mustang GT, I bought another bottle and added it and the tick is now gone again. We'll see if it lasts. I can tell you that my fuel economy has improved. I have a little over 11,000 miles now and I always display my fuel economy meter and I use it. I've never reset my average fuel economy meter since the day I bought the car new. I've been pretty well stuck at 21.6 MPG for the last couple months. Since I've put in the Ceratec, my average fuel economy has increased to 21.8 MPG, so it's jumped 0.2 MPG in roughly 2 weeks. With over 11,000 miles included in the average, it takes a pretty significant improvement in friction to make that average move that much in that short a time. Even if my tick comes back again, I'm sold on Ceratec for the friction reduction alone. I'll update the review again if the tick comes back.
Original Review:
My 2018 Mustang GT developed the infamous BBQ/Typewriter tick immedaitely after my first oil change. I used Mobil One synthetic at 3500 miles on my first oil change. I did my 2nd oil change at 10K miles with Mobile One, but the tick was still present. After seeing people on YouTube having success eliminating their tick with Ceratec and after reading the one other review of a 2018 Mustang GT owner here on Amazon, I decided to try it.
I ordered 1 bottle. It arrived on a Friday and poured it in immediately after I got home from work. It's an hour drive one way to work, so the engine was at operating temperature, where, in my case, the tick goes away. I only get it when the engine switches from high idle to normal idle after a cold start and the tick is quite loud for at least the 15 minutes it takes for me to get to the drive through where I get my morning coffee, where I can really hear the tick echoing off the wall.
After pouring it in, I started the car and let it idle, but didn't really notice any change. I then took it for a drive and did some hard pulls to get the engine to rev under load to the red line. After that, I put the car in the garage until I drove to work on Monday.
When I went to the drive through to get my morning coffee, there was no tick! It was gone! I listened real hard, but all I could hear was the normal direct injector pump noise. Then, after my hour long drive to work, I left car running and got out to listen. With the hood closed, it was quieter than at any time since I bought it. It was virtually silent. Even the DI pump noise was barely audible. The car also sounded and felt different during the drive to work. The engine seemed like it was smoother somehow. It might have been my imagination, but after the silence in my parking spot at work, I wouldn't be surprised if the engine did run smoother.
At any rate, I only used 1 bottle to treat the 10 quarts of oil, which is half the amount the mfg says to use. So, I'll see how long it lasts, but it definitely worked even at half its normal concentration. I highly recommend it for anyone who has the 2018 Mustang GT tick.
WAS THIS REVIEW HELPFUL?YesReportShare
Reviewed in the United States on January 14, 2019
★★★★★ 5
Must have in modern high compression GDI engines!
Style: Modifier
So bought this for my new Mazda 3 Turbos' first oil change. I was originally going to use Liqui Moly MoS2, due to the OE Mazda oil using a very high Moly PPM (800ish) formula and not having easy access to a similarly formulated oil. After doing some more reading i decided to use Ceratec instead, mostly because it doesn't make the oil look super dark (for warranty purposes, If for some reason i do have a problem with the engin i don't want the dealer saying I just didn't change my oil). So initial results are awesome, the valve noise is pretty much gone. And the engin just feels smoother, and sounds like is not even trying when reving it out. With that success I bought another one for my girlfriends non turbo CX30 when i changed her oil. Her engine has always been just a little noisier than my old non turbo mazda 3, and my new Turbo model. I've used the same oil in both (Pennzoil Ultra Platinum 0w20 or 5w30 in the turbo). It had the normal lifter noise, but it always sounded raspy when accelerating hard, like it was really at the edge when floored. So as a before and after test I changed the oil fist with NO Ceratec, engin sounded happier, ran a little smoother, but basically the same as before, Normal stuff after an oil change. So I added the Ceratec, literally you could hear the lifter noise melt away as it mixed with the oil, I was in my garage so the effect was even more stark. The engine also idled smoother, to the point if you were in the car, you wouldn't know it was on without the engine RPM readout. So i took it for a test drive down the road and stepped on it after getting it up to Temp. The raspiness was completely gone, it sounded like it was happy as a clam reving right up to redline. This wasn't a "i think it might be better" differance, it was a night and day difference, a wow that impressive difference. As for fuel consumption reduction claims, i don't know yet, from what i read you need to dive it 300-400 miles to get a valid result. I only have 150ish on mine and 75 on hers. First impressions were really positive, highly recommend to anyone wanting to keep a car for a really long time. Only downside is the price, this stuff is really expensive... but i look at it
like this, $600 over the life if the vehicle if you keep it to 150K miles, with 6k oil change intervals is pretty cheap insurance. compared to an engine rebuild.
WAS THIS REVIEW HELPFUL?YesReportShare
Reviewed in the United States on July 21, 2021
★★★★★ 4
Results after 1500 miles....
Style: Modifier
Seems to have made my engine a little less noisy at startup.
WAS THIS REVIEW HELPFUL?YesReportShare
Reviewed in the United States on March 3, 2026
★★★★★ 5
Been Using For a good While
Style: Modifier
Always quality product
WAS THIS REVIEW HELPFUL?YesReportShare
Reviewed in the United States on May 29, 2026